The PLS-1 lock is installed on Aiko safes of the T series.ġ. Call the wizard, not an expensive procedure with a complete disassembly of the lock and replacement of the memory card. Without a valid code, it is not possible to change the code.
#DEFAULT COMBINATION FOR MEILINK SAFE CODE#
The safe is open, I don't remember the code, I can't change the code Call the wizard to open the safe and troubleshoot. The external power wires were pinched when assembling the safe. When external power is connected, the battery heats up and the safe does not open. There are many reasons, if you water the flower on the safe and water spills on the keyboard, then it is moisture on the keyboard board. The safe does not open.ĭefective keyboard. After opening the safe, I repeatedly checked the code in the microcircuit that was put into memory (you can pull out the code using programmer of microcircuits) and always made sure that this was not a lock glitch but a bad client memory. I have heard from clients dozens of times “I remember the code”, “I have been opening it for three years, I can’t forget it”, “I have all the moves written down,” etc. The code you entered does not match the code in the lock memory. After three attempts, the lock is locked. I remember the code 200%, but after dialing the code, the red LED lights up. Opening the Valberg safe and replacing the electromagnet. Try to turn the knob quickly while the LED is on. The safe reacts to pressing the keys and the green LED lights up for half a second after dialing the code, but the handle does not turn.Īn electromagnet in the inner block of the castle dies or died. You have to carefully open the safe and change the lock part. If the stump breaks, then unlocking is not possible. In the internal block a small silumin "stump" breaks, which holds the unlocking element. There is a weak point on the KABA MAUER Code combi K 82021 locks. The safe reacts to pressing the keys and the green LED lights up after dialing the code, but the handle does not turn. If it is impossible to supply power, call the master, the safe must be carefully opened and the malfunction eliminated. If the safe was in a damp place, then the keyboard is probably faulty. Burned internal electronic block of the lock
#DEFAULT COMBINATION FOR MEILINK SAFE PLUS#
Perhaps the main power battery was sweating and shorted plus to minus in the internal connector. It often happens that when the external panel is installed, the wires of the external connector are pinched. Safe does not open, the lock does not respond to the button ON when external power is connected.Ĭheck the plug-in battery for more than 7.5V voltage (even a new battery may be discharged). Most likely the battery is dead, connect the external power to the connector under the black sticker, between the pen and the keyboard How to open the safe lock if you forgot your password.
0 kommentar(er)
